Dual Guard Premium Seal

Premium Seal™ DG Dual Guard is a 2-in-1 formula that combines the benefits of both a film-forming and a penetrating sealer in one easy coat. It will give a high gloss, wet look to new projects but can also be used to revitalize a previously sealed surface. It is commercial strength for high-traffic areas and can be used in vertical applications.

Applications

• Concrete pavers
• Wetcast
• Many natural stones
• Exposed aggregate
• Stamped concrete
• Vertical applications

Instructions

CLEAN

• Wait 28 days after installing polymeric sand before sealing.
• Thoroughly sweep surface of joint sand or loose material.
• Spot clean if needed with one of the SRW Specialty Clean™ products. Then prepare surface with an SRW Products General Purpose Cleaner.

CLIMATE

• After cleaning, wait at least 24 hours before sealing. Surface must be completely dry.
• Recommended application temperatures are 50°F – 80°F (10°C – 27°C) from installation through the cure process.
• Do not apply if inclement weather is forecasted within 24 hours.

APPLY

• STIR THOROUGHLY.
• Apply with an SRW Products approved Slit Foam Roller and sprayer.
• Spray then back roll. This prevents an uneven finish. A 2-person application is recommended.
• Always spray against a wet edge and do not overlap a previously sealed and dried area. Start at the highest project elevation.
• Do not allow sealer to pool on surface or in joints.

CURE

• Allow sealed area to dry and cure 24 hours.
• Protect area from water and rain until dry.
• Dry-tack free: 25 minutes
• Foot traffic: 24 hours
• Vehicle traffic: 72 hours
• Note: All calculations based on 68ºF – 77ºF (20°C – 25°C)